Application Equipment of Filter plate for Metal

filters (1) spindle motor power: 3kw (2) mixing motor power : 5.5kw (3) ISO9001 certificate

filters

Installation steps

1) The people of installing the filter board should do it beside the filter discharge scraper plane. The rotor of the filter need to be adjusted by inching method in the discharge area which one of the filter boards will be coming. Then loose the fixed screw of the film scraper and let the scraper to be low down.    2) Before exchanging the filter board, please carefully clean the mineral powder in the fitting surface and hole of the rotor flange, avoiding causing the inaccuracy when installing the bolts between them. Please also clean the fitting circle of the filter board.    3) Insert the nozzle of the filter board into soft joints of the filter. Fasten one of the bolt but not tightened firstly and another bolt which is not tightened too. Then correct disk indexing position of the installation for filter board, and upper and lower corners. Please less tighten them until slight compact in order to prevent the movement up and down. Please not move the rotor at this moment. Install the second filter board at the same method. Then adjust the space between two pieces of the filter boards and format the curvature without peak but tighten the bolts by ring spanner according to your satisfaction.

type	BS-3	BS-8	BS-12	BS-16	BS-20	BS-24	BS-30	BS-36	BS-45	BS-60	BS-80
Filter a plank amount(Piece)	36	48	72	96	120	96	120	144	180	180	240
Disk amount(Turn)	3	4	6	8	10	8	10	12	15	15	20
Each filter area(m2)	1	2	2	2	2	3	3	3	3	4	4
filter area(m2)	3	8	12	16	20	24	30	36	45	60	80
Disk rotational speed	0.5-1.5
Power of main motor(KW)	1.5	1.5	1.5	2.2	2.2	2.2	2.2	3	3	4	4
Stirring Motor Power (KW)	2.2	2.2	2.2	3	3	3	3	5.5	5.5	5.5	5.5
Vacuum (Mpa)	-0.09~-0.08

Application Equipment of Filter plate for Metal